Frosted Details (MJM)

QualityUltra Smooth Surface
Min Details0.1mm
Minimum wall Thickness0.6mm
Maximum Size284x184x203mm
Heat Resistance80°C
ColorTransperent/ Clear

Frosted Ultra Detail and Frosted Extreme Detail are both made of a UV cured acrylic polymer. While both offer high resolution, Frosted Extreme Detail uses a 16 micron layer height to produce incredibly fine features, making it a great choice for miniatures, model trains, and products with very fine embossed or engraved details. Both materials are well suited for painting, and are relatively brittle, especially when features are thin. The material is heat resistant up to 80°C / 176°F degrees.

This material is watertight, not dishwasher safe, not recyclable, not foodsafe. Frosted detail plastics are heatproof to 80℃ / 176℉ degrees. Higher temperatures may significantly change material properties.

This material is printed using the Multijet Modeling (MJM) process. Molten plastic is deposited onto an aluminum build platform in layers using several nozzles, essentially like a large print that sweeps across the build layer. As the heated material jets onto the build plate, it solidifies instantly. After each layer is deposited, it is cured, or polymerized, by a wide area UV lamp. The next layer then applied, and through this repeated process layers of thermoplastic build up into a model. When printing is finished, we remove the models from the tray and put them into an oven that melts away the wax support material. Next, we put the models into an a ultrasonic oil bath to remove any remaining wax residues, and then a ultrasonic water bath to remove any oil on the model. Finally, we inspect the models and dry them by hand.

Call Now ButtonClick to Call
Download AR Brochure PDF
close slider